产品主要特点：
为了操作安全，使用时，必须戴好绝缘手套或者可根据情况使用射枪式绝缘操作杆
配有活栓，收紧索，和安全闩
头部材料使用铝合金，可以放置活栓
头部下方的塑料透明罩能很快捷清楚地观察
消弧器应与绝缘跳线配套使用
选用6605时，可另外单独配置独立的绝缘跳线
选用6600时，绝缘跳线是固定安装在消弧器上的
用户应事先指明所需连接绝缘跳线的各种参数
6600A是含2米长，额定电流为250A的绝缘跳线
产品编号 |
说明 |
Z大使用电压（KV） |
额定电流（A） |
重量（kg） |
6600 |
可固定接引流线型 |
29.2 |
300 |
5.9 |
6605 |
螺栓型 |
29.2 |
300 |
6.2 |
6600A |
固定接引流线型 |
29.2 |
250 |
11.9 |
LOAD PICK UP TOOLS
Two models available
Load Pick Up Tool for installation on a cable assembly (clamp and cable sold separately)
Load Pick Up Tool with stud to utilize your ready made jumpers
Both models have a nominal rating of 27KV*
Current Rating 300 Amps*
Note: While the maximum rating for each model is stated above, the actual rating will be the lesser
of these values, or of the rating of the components used with the Load Pick Up Tool. If 15KV jumper
cable is being used, the entire assembly will be rated at 15KV. If the jumper cable is less than 2/0
AWG, the current rating will be reduced accordingly.
Can be installed with a shotgun stick or with rubber gloves, in accordance with your company’s safe
work practices
Both tools come completely self contained with cocking tool, firing lanyard, and safety latch
The head casting is aluminum alloy and also serves as a storage port for the cocking tool
Clear plastic housing below the head casting allows for quick, easy visual inspection
Each tool comes complete with an operating and maintenance manual
Note: Load Pick Up Tools are not load break devices
Note: For use on 15KV or 25KV systems only
| CAT NO |
DESCRIPTION |
MAIN LINE RANGE |
KV RATING |
CURRENT |
LBS |
|
| |
|
MAXIMUM |
MINIMUM |
|
|
|
| 6600 |
LOAD PICK UP TOOL / CABLE *CLAMP AND CABLE SOLD SEPARATELY |
6 SOLID .16 DIAMETER |
1033 MCM 1.25 DIAMETER |
29.2KV MAXIMUM |
300A MAXIMUM |
5.9 |
| 6605 |
LOAD PICK UP TOOL / STUD |
6 SOLID .16 DIAMETER |
1033 MCM 1.25 DIAMETER |
29.2KV MAXIMUM |
300A MAXIMUM |
6.2 |
| 01-089 |
PADDED CARRYING CASE FOR 6605 |
2.7 |
||||
| CONTACT FACTORY FOR ASSISTANCE IN
CONFIGURING A LOAD PICK UP TOOL CABLE ASSEMBLY |
||||||
